+2023 NISSAN Z TRUCONTROL BY STILLEN INLINE POWER MODULE - TC101001

STILLEN is excited to announce the TruControl by STILLEN Inline Power Module for the +2023 Nissan Z. The TruControl by STILLEN Inline Power Module is a quick and easy way to add more power to your Nissan Z with the V6 VR30DDTT engine. It makes great power from the factory and the TruControl by STILLEN Inline Power Module is a great way to add even more power for a low cost and simple installation.

We achieve this power by integrating the Power Module into the factory wiring harness and adjusting certain parameters to increase boost pressure and make significant power/torque gains across the entire power band. Installation only takes about 15 minutes and does not require any special tools.

Features and Benefits:

• +70 flywheel Horsepower gain*
• +86 ft. lbs. Torque gain at the wheels*
• Very easy installation
• Bluetooth integration
• No wiring or specialty tools required
• Easy removal

• Not for sale in California

*Results may vary

The Numbers

From the factory the Z is rated at 400 flywheel horsepower.  On our dyno we saw a maximum wheel horsepower output of 336 horsepower at 6300 RPM*.  This is about a 15% drivetrain loss.  Great work by NISSAN to get all of that power to the ground.  After installing our TruControl by STILLEN Inline Power Module the dyno reported back a Max horsepower output of 392 wheel horsepower at 5390 RPM*.  Simply by installing the Trucontrol ECU into our Z we were able to gain more than 70 flywheel horsepower*.  

Even more amazing than the gains in horsepower are the gains in torque output.  As you can see in the dyno the factory torque curve begins to decline at just over 3500 RPM*.  At this RPM the stock car produced 338 ft. lbs of torque.  The TruControl by STILLEN Inline Power Module is at 393 ft. lbs of torque*.  Whereas the factory torque curve begins to decline, the TruControl by STILLEN Inline Power Module curve only increases further until reaching its maximum output at 4720 RPM*.  At this point the factory output has declined to 323 ft. lbs.* while the TruControl by STILLEN Inline Power Module has managed to increase to 409 ft. lbs of torque*.  Truly amazing gains that make the Z an absolutely incredible car to drive.

*Results may vary

Easy to Use

With the engine on or with the key on, you can go through and [-/+] select which calibration you want to run at any point in time. You can use the Tuning: Pro App which also controls and resets all calibrations based on what you input in the application.

The TruControl by STILLEN Inline Power Module comes preloaded with up to 7 different maps for your Toyota Tundra. These maps are going to range anywhere from Race mode to Sport mode to Eco mode.