Ridetech 67-70 Ford Mustang Front Lower StrongArms Control Arms

12102899

RideTech StrongArms Tubular Control Arms

RideTech StrongArm tubular control arms are designed to stiffen up your vehicle's chassis, while providing a smoother ride. They feature a tubular design that offers maximum strength—and are available for a variety of front and rear positions. The control arms include bushings and factory-installed ball joints (front), making installation easier. Get optimum suspension geometry with a set of RideTech StrongArm tubular control arms; order the kit recommended for your vehicle.

• RideTech build the arm one piece to eliminate the strut rod.
• Where the factory strut rod uses a rubber bushing to attach to the car RideTech uses a bearing setup. The bearing setup gets rid of the compression that is experienced with hard braking and cornering.
• RideTechs upper control arm cross shaft lowers the pivot point. By lowering the pivot point of the upper control it increases the camber gain, this helps keep the tire flat on the road surface when you are going through hard corners. This is all done with no additional drilling, the drop is built into the control arm cross shaft.
• The lower arm uses an eccentric eliminator. This plate has multiple positions to be used in aligning the car, and once they are set you do not have to worry about your alignment moving. Any fine tuning that is needed, can be done with the upper control arm because it is fully adjustable.